- 7 -
Enter user code on keypad then press #. When you press the first number of the
user code, press and hold the first number key until you hear a beep and the keypad
shows blue light.
If the user code is authenticated, you will hear one long beep and the keypad will
show blue light. The lock will unlock. Otherwise, you will hear two short beeps and the
keypad will show red light.
7. Delete a single user code:
7.1. Login using Programming code or an administrator fingerprint. Press * then
enter Programming code, followed by pressing #, or Press * followed by placing an
administrator fingerprint on the sensor. If login is successful, you will hear one long
beep and the keypad will show blue light. Otherwise, you will hear two short beeps and
the keypad will show red light. Repeat if login fails.
7.2. Press 5 *.
7.3 Enter a user ID, press #. If the deletion is successful, you will hear one long
beep and the keypad will show blue light. Otherwise, you will hear two short beeps and
the keypad will show red light.
7.4. Repeat step 7.3 within 5 seconds if you want to delete more user codes. The
system will log out after 5 seconds if you don’t press any button.
8. Delete all user code:
Follow 7.1 to login the system, then press 6 *, then press 6 * again, and then
press #. If the deletion is successful, you will hear one long beep and the keypad will
show blue light. Otherwise, you will hear two short beeps and the keypad will show red
light.
Others
9. Key unlock: Insert a key in the cylinder to rotate 180° CLOCKWISE, then
rotate lever to unlock. Rotate a key 180° COUNTER CLOCKWISE then take out the
key to lock.
10. Low battery warning: When short quick beeping occurs during operation,
please change the batteries as soon as possible.
11. Additional power source: When power runs out, attach 9V battery to the
ports that are located at the bottom of the lock to power up the system.
12. Passage mode enabling/disabling:
The lock can be set at a passage mode. When the lock is in a passage mode,
anybody could open the door by pushing down the handle
12.1. To enable a passage mode, press # within 5 second after any user unlocks
the lock using either a fingerprint or a user code.
12.2. Any user unlocks the lock by using a fingerprint or a user code will disable a
passage mode,
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals