- 4 -
Key override feature could be disabled.
9V battery may be attached as an additional power source.
Double-shell heavy duty construction design.
Low power alert.
Specifications:
Optical sensor.
Standard 12-key keypad.
Tubular latch.
Adjustable backset 2 ⅜” or 2 ¾”.
Fit door thickness between 1 ¼” and 2 ¼” (Order screws for door thickness
between 2 ¼” and 2 ½”).
Operation temperature from -4°F to 150°F (-20°C to 65°C).
Powered by 4 AA Alkaline batteries (NOT included).
Lock designed for INTERIOR door ONLY.
One year limited manufacturer’s warranty.
Important Note:
1. For valid key entry, press and hold a key until you hear a beep and see blue light, then
release the key.
2. During programming, system will log out if a user doesn’t press any keys for 5
seconds. The keypad will flash red twice to indicate system log out. If you make a
mistake during programming, please wait for the system to log out and then login again.
3. Try to use finger to unlock for 5 or more times after you enroll your fingerprint in
system. Let system catch more fingerprint templates.
4. Fingerprint sensor should activate automatically when a user place finger on the
sensor, otherwise press # to active fingerprint sensor. To solve the problem, take one
battery out, press any key for 2 seconds, and then place the battery back.
5. Improper operation may cause system crash; the system doesn’t accept any command.
To solve the problem, take one battery out, press any key for 2 seconds, and then place
the battery back. Try again if system doesn’t recover. Reset system if problem is still
there.
I. Programming Code
The lock has one Programming Code. Programming Code allows a lock owner to login
the lock system and register a user password or a user fingerprint. The factory-set default
Programming Code is 123456. It is recommended that a lock owner should change the
default Programming Code to a customized Programming Code. A customized Program
Code can be any combination of 4-12 digits.
To change Programming Code, please follow the following steps:
press 0 and then *
Comments to this Manuals